Real steam knowledge
Techs who understand near-boiler piping, main vents, and how one-pipe and two-pipe systems are supposed to behave.
So much of New York runs on steam heat: prewar apartment buildings, brownstones, and co-ops with radiators in every room. Steam is its own craft, and a general handyman often gets it wrong. We connect you with technicians who actually understand one-pipe and two-pipe steam systems.
Steam problems tend to be about balance. Pressure, water level, venting, and pitch all have to be right. Banging pipes and uneven heat usually mean something is off in that chain. A steam-literate tech can trace it instead of just swapping parts.
Call (646) 798-2656What’s included
Techs who understand near-boiler piping, main vents, and how one-pipe and two-pipe systems are supposed to behave.
Checking the pressuretrol, gauge, and safety controls. Most steam systems should run on ounces of pressure, not high psi.
Servicing the low-water cutoff and auto-feeder so the boiler keeps a safe, steady water line.
Diagnosing air vents and main venting so steam reaches every radiator and the banging stops.
Questions
Water hammer usually comes from condensate trapped in the pipes, often from pitch, poor venting, or waterlogged mains. A steam tech can find the cause instead of living with the noise.
Often it’s the air vent, not the radiator. On one-pipe steam a stuck or wrong-sized vent stops steam from filling the radiator fully. It’s usually a straightforward fix.
Very likely. Most residential steam runs best on well under 2 psi. A pressuretrol set too high wastes fuel and can worsen banging and uneven heat.
Where we dispatch
Related services
24/7 no-heat & breakdown response.
New and replacement boilers.
Hydronic & baseboard systems.
Fast diagnosis when the heat is out.
Annual service & inspections.
Call and we’ll connect you with a licensed NYC boiler technician who can help right now.
Call (646) 798-2656